AEG ELECTROLUX F 55420 W 0 P - Manual (Page 40)

Problem Possible cause Possible solution
The quantity of detergent
was too much. Make sure that you add the
correct quantity of detergent
in the dispenser before you
start a programme.
Dry water drop
stains on glasses
and dishes. The released quantity of
rinse aid was not sufficient . Increase the released quanti-
ty of rinse aid.
The quality of the detergent
can be the cause. Try a different brand of de-
tergent.
The dishes are wet. • The programme had no
drying phase.
• The programme had a
low temperature drying
phase.
For better drying results,
keep the door ajar for some
minutes.
The dishes are wet
and matt. The rinse aid dispenser is
empty. Make sure that there is rinse
aid in the rinse aid dispenser.
The quality of the rinse aid
can be the cause. Try a different brand of rinse
aid.
The quality of the combi
detergent tablets can be
the cause. • Try a different brand of
combi detergent tablets.
• Activate the rinse aid dis-
penser and use the rinse
aid together with the com-
bi detergent tablets.
Activating the rinse aid
dispenser with the multitab
function activated
1. Press the on/off button to activate the
appliance.
2. Make sure that the appliance is in set-
ting mode. Refer to ‘SETTING AND
STARTING A PROGRAMME’.
3. Turn the programme knob until the
display shows two horizontal status
bars.
4. Press and hold Multitab and Delay at
the same time until the indicators ,
, and flash.
5. Press Delay.
• The indicators and go off.
• The indicator
continues to flash.
• The display shows the setting of the
rinse aid dispenser.
Off
On
6. Press Delay again and again to
change the setting.
7. Deactivate the appliance to confirm.
40