NEC LT81 - Manual (Page 23)

PC CONTROL
VIDEO INPUT
RGB INPUT OUTPUT OUTPUT
S-VIDEO VIDEO L ( MONO ) -R-AUDIO
OUTPUT
INPUT
RGB RGB AUDIO AUDIO
REMOTE
CONTROL
Document Camera
VCR, Laser Disk Player or DVD Player
Wiring Diagram
To video, S-video, and audio
inputs on the projector
43
IBM VGA or Compatibles Macintosh or Compatibles (Desk top type)
Remote Mouse
Receiver PS/2 mouse adapter
(supplied)
Mac ADB adapter
(supplied)
INSTALLATION 44
Pin adapter for Macintosh
(supplied)
DVD Player with Y/Cb/Cr output
Signal cable (supplied)
To mini D-Sub 15-pin connector on the Projector
Remote Mouse
Receiver
Remote Control Guideline
1. Plug the serial cable with the remote mouse receiver into your computer's mouse port and restart your computer to gain remote mouse
control.
2. When using the remote control's built-in infrared mouse on a laptop computer, the laptop's mouse, trackball or trackpad will be disabled.
Disconnect the infrared receiver and restart your computer to regain trackball or trackpad mouse control.
3. If the screen goes blank while using your remote control, it may be the result of the computer's screen-saver or power management
software. If you accidentally hit the OFF button on the remote control, wait one full minute and then press the ON button to resume.
To RGB input on the projector