Nikon COOLPIX S9 - Manual (Page 27)

15
Inserting the Battery
Fi
rst
St
ep
s
Turning On and Off the Camera
To turn on the camera, press the power switch. The
power-on lamp (green) will light for a moment and
the monitor will turn on.
To turn off the camera, press the power switch
again.
(If the camera is turned off, press o for about a
second to turn the camera on in playback mode.)
j
Note on the Battery
Read and follow the warnings and cautions on pages ii to iv and 112 of this manual.
j
Removing the Battery
Turn the camera off before removing the battery. To eject
the battery, open the battery-chamber/memory card slot
cover and slide the battery latch in the direction shown. The
battery can then be removed by hand. Note that the battery
may become hot during use; observe due caution when
removing the battery.
k
Power Saving Function
In shooting mode, the monitor will dim to reduce the drain on the battery if no operations are
performed for about five seconds. The monitor will brighten when camera controls are used.
When no operations are performed for fifteen seconds, the monitor turns off and the power-
on lamp blinks. If no operations are performed for another fifteen seconds, the camera enters
standby mode. If no operations are performed for another three minutes, the camera turns
off. To reactivate the camera from standby mode, press the shutter-release button halfway.
The amount of time allowed to pass before the camera enters standby mode can be specified
from the auto off menu (c 104).