Nilfisk-Advance America SR 1100S - Manual (Page 74)

ENGLISH USER MANUAL
24 146 2559 000(2)2007-02 A SR 1100S P
TROUBLESHOOTING
Trouble Possible cause Remedy
When the ignition key is turned to "I", the engine
does not start.
The battery connector (46) is disconnected. Connect the battery connector.
The engine oil level is low. Add engine oil. (1)
The fuel level is low. Refuel. (1)
The fuel does not reach the carburettor. Check the connecting hose. (1)
The hood is not properly closed. Close the hood properly.
The spark plug does not produce a spark. Clean/replace the spark plug. (1)
The engine stops during operation.
The engine oil level is low. Add engine oil. (1)
The fuel level is low. Refuel. (1)
The machine does not move when pressing the
pedal (2).
The parking brake is engaged. Disengage the parking brake.
When starting the machine with the ignition
key (82), the pedal (2) is pressed, or the
operator is not yet on the driver's seat. Start the machine with the ignition key (82),
only after being on the driver's seat and
without pressing the pedal (2).
The main broom does not work. The circuit breaker (47) is deactivated.
Reset the fuse (47) by pressing the relevant
switch.
The side brooms do not operate.
The main broom is not lowered. Lower the main broom.
The circuit breaker (48) is deactivated.
Reset the fuse (48) by pressing the relevant
switch.
The dive system malfunction led (49) is fl ashing. The drive system is malfunctioning.
To detect the failure, refer to the Service
Manual (at any Nilfi sk-Advance Service
Center).
(1) For the relevant procedure, see the Petrol Engine Manual.
For further information, refer to the Service Manual, available at any Nilfi sk-Advance Service Center.
SCRAPPING
Have the machine scrapped by a qualifi ed scrapper.
Before scrapping the machine, remove and separate the following materials, which must be disposed of properly according to the
Law in force:
Batteries
Engine oil
Polyester dust fi lter
Main and side brooms
Plastic hoses and components
Electrical and electronic components (*)
(*) Refer to the nearest Nilfi sk-Advance Center especially when scrapping electrical and electronic components.
–
–
–
–
–
–