Zanussi ZDT 16002 FA User Manual
Page 20
Water hardness
Water softener
adjustment
German
degrees
(°dH)
French
degrees
(°fH)
mmol/l
Clarke
degrees
Manual
Electronic
11 - 14
19 - 25
1.9 - 2.5
13 - 17
1
3
4 - 10
7 - 18
0.7 - 1.8
5 - 12
1
2
< 4
< 7
< 0.7
< 5
1
2)
1
2)
1) Factory position.
2) Do not use salt at this level.
Manual adjustment
1
2
Turn the water hardness
dial to the position 1 or 2.
EElectronic adjustment
1. Press the on/off button to activate the appliance.
2. Make sure that the appliance is in setting mode. Refer
to ‘SETTING AND STARTING A PROGRAMME’.
3. Press and hold function buttons (BB) and (CC) at the
same time until the indicators of function buttons (AA),
(BB) and (CC) flash.
4. Press function button (AA).
• The indicators of function buttons (BB) and (CC) go
off.
• The indicator of function button (AA) continues to
flash.
• The acoustic signals operate. Example: five inter-
mittent acoustic signals = level 5.
• The display shows the setting of the water soften-
er. Example:
= level 5.
5. Press function button (AA) again and again to change
the setting.
6. Deactivate the appliance to confirm.
Filling the salt container
Caution! Only use dishwasher salt. Other products
can cause damage to the appliance.
Water and salt can come out from the salt container when
you fill it. Risk of corrosion. To prevent it, after you fill the
salt container, start a programme.
1
2
3
Put 1 litre of water in the
salt container (only for the
first time).
4
220