Zanussi ZDT 16002 FA - Manual (Page 26)

Problem Possible cause Possible solution
The quantity of detergent was too much. Make sure that you add the correct quan-
tity of detergent in the dispenser before
you start a programme.
Dry water drop stains on
glasses and dishes.
The released quantity of rinse aid was
not sufficient .
Increase the released quantity of rinse aid.
The quality of the detergent can be the
cause.
Try a different brand of detergent.
The dishes are wet. • The programme had no drying phase.
• The programme had a low tempera-
ture drying phase.
For better drying results, keep the door
ajar for some minutes.
The dishes are wet and matt. The rinse aid dispenser is empty. Make sure that there is rinse aid in the
rinse aid dispenser.
The quality of the rinse aid can be the
cause.
Try a different brand of rinse aid.
The quality of the combi detergent tab-
lets can be the cause.
• Try a different brand of combi deter-
gent tablets.
• Activate the rinse aid dispenser and
use the rinse aid together with the
combi detergent tablets.
Activating the rinse aid dispenser with the multitab
function activated
1. Press the on/off button to activate the appliance.
2. Make sure that the appliance is in setting mode. Refer
to ‘SETTING AND STARTING A PROGRAMME'.
3. Press and hold function buttons (BB) and (CC) at the
same time until the indicators of function buttons (AA),
(BB) and (CC) flash.
4. Press function button (BB).
• The indicators of function buttons (AA) and (CC) go
off.
• The indicator of function button (BB) continues to
flash.
• The display shows the setting of the rinse aid dis-
penser.
Off
On
5. Press function button (BB) to change the setting.
6. Deactivate the appliance to confirm.
7. Adjust the released quantity of rinse aid.
8. Fill the rinse aid dispenser.
Technical information
Dimensions Width / Height / Depth (mm) 596 / 818-898 / 555
Electrical connection Refer to the rating plate.
Voltage 220-240 V
Frequency 50 Hz
26