NDC comm CompuFax - Manual (Page 16)

2
1.2 Hardw are Installation
This procedure is performed only for Full Device Server software.
1.2.1 Fax Modem Devic e
A Class II fax modem device is required for use with the CompuFax product. The MultiTech MT2834ZDX
fax modem (19,200 data/ 14,400 fax) has been tested for performance and reliability, and is the recommended
modem device.
1.2.2 Modem Cabling
A standard serial modem cable can be used to connect the modem to the terminal server (LAT) or hard-wired
terminal port (TX, TT, etc.). The following signal lines must be connected:
Pin 2 Transmit
Pin 3 Receive
Pin 7 Signal Ground
1.2.3 Term inal Port Charac t erist ic s
To ensure transmission of files via CompuFax, the terminal port or LAT port characteristics must be
configured correctly. These terminal parameters will be the same whether the modem device is connected to a
DEC server or to a direct-connect port (TX, TT, etc.). Use the examples shown here as the proper setting of
the port characteristics.
$ SHOW TERMINAL
Terminal: _LTA9008: Device_Type: Unknown Owner: Fax Server
Username: SYSTEM
LAT Server/ Port: DS100/ PORT_8
Input: 19200 LFfill: 0 Width: 80 Parity: None
Output: 19200 CRfill: 0 Page: 24
1--2 CompuFax Installation
Terminal Characteristics:
Interactive No Echo Type_ahead No Escape
Hostsync TTsync Lowercase Tab
No Wrap Scope No Remote Eight-bit
No Broadcast No Readsync Form Fulldup
No Modem No Local_echo No Autobaud Hangup
No Brdcstmbx No DMA Altypeahd Set_speed
No Commsync No Line Editing Overstrike editing No Fallback
No Dialup No Secure server No Disconnect Pasthru
No Syspassword No SIXEL Graphics No Soft Characters No Printer Port
Numeric Keypad No ANSI_CRT No Regis No Block_mode
No Advanced_video No Edit_mode No DEC_CRT No DEC_CRT2
No DEC_CRT3 No DEC_CRT4 VMS Style Input