NDC comm CompuFax - Manual (Page 90)

6 6
time.
F Fatal. The attempted action did not work.
In the previous example, the first message has an "F" severity level and the second one has
an "S" severity level.
9.1.3 Message Rout ing
Since your fax documents are queued and not always sent right away, the majority of CompuFax messages are
not sent back to your terminal, because you may not be logged in to the system at the time the error occurs.
The only time a message is sent back directly to the user's screen is when a document cannot be placed into
the queue at all, such as shown here:
$ FAX SEN D X.YZ
%FAX-F-FILEACCFAIL, File access failure for ALPHA$DKA300:[FAX]X.YZ;
-RMS-E-FN F, file not found
(In the above example, also note the second message, which indicates that an error was also detected in
DEC's Record Management System (RMS). Messages are sent back to the user via VMS MAIL or, optionally,
to the Operator's Console. They may also be sent to a log file.
If you want to make sure you are notified of a fax document's completion status, you can do so by using the
/ NOTIFY qualifier with the SEND command. This will inform you by VMS Mail message whether your fax
was sent successfully or, if it failed, it will notify you after the last attempt.
The minimum severity level of messages sent to the various locations is determined by the System Manager
during the CompuFax setup procedures. For more information, see Chapter 7, SEND / NOTIFY, SEND
/ [NO]MAIL.
9.2 Alphabetical Listing of Messages
This section lists CompuFax messages alphabetically, by Descriptor.
ABORT
Message:
%FAX-I-ABORT, Entry aborted
Description: A document transmission has been successfully aborted (if the document was active) and the
entry removed from the queue.
User action:
None.
BADPARAM
Message:
%FAX-F-BADPARAM, Illegal parameter value: xxxx
Description: An illegal command parameter has been entered in the server options file.
User action: The incorrect parameter value should be corrected.
BUGCHECK
Message:
%FAX-F-BUGCHECK, Internal consistency failure in module xxxx, code nn
Description: This indicates an internal error has occurred.
User action: Any information available about the circumstances should be reported to NDC tech
support.
BUGCHECK
Message:
%FDB-F-BUGCHECK, Internal consistency failure in module xxxx, code nn