N-Tron 102PC-SE User Manual
Page 14
(Revised 2010-11-15)
14
TROUBLESHOOTING
1. Make sure the (Power LED) is ON.
2. Make sure you are supplying sufficient current for the version chosen. Note: The Inrush current
will exceed the steady state current by ~ 2X.
3. Verify that Link LED‟s are ON for connected ports.
4. Verify cabling used between stations.
5. Verify that cabling is Category 5E or greater for 100Mbit Operation.
6. Verify that a null-modem cable is being used to connect other DCE devices to the serial port, or that
a straight through cable is being used to connect a PC to the serial port.
SUPPORT
Contact N-Tron Corp. at:
TEL: 251-342-2164
FAX: 251-342-6353
FCC STATEMENT
This product complies with Part 15 of the FCC-A Rules.
Operation is subject to the following conditions:
(1) This device may not cause harmful Interference
(2) This device must accept any interference received, including interference that may cause undesired
operation.