National Products LMX9820A - Manual (Page 4)

www.national.com 4 (Confidential) Revision 0.2
LMX9820ADEV
: LMX9820A Simpl
y
Blue Module Kit User’
s
Guide
1.0 Kit Setup
1.1 KIT CONTENTS
The Simply Blue module kit (LMX9820ADEV) contains the
following items:
• Texas Motherboard
• Austin Daughterboard
• Sedona Board
• Null modem cable
• 100V - 240V AC to 5V DC power supply
• Antenna
• CD-ROM containing documentation and software
1.2 REQUIREMENTS AND SETUP
1.2.1 Basic Requirements
• x86 PC with serial port
• One of the following Microsoft Windows Operating
Systems is required:
— Windows 2000
— Windows XP
1.2.2 Software Included in Kit
• Simply Blue Commander:
— Command oriented tool to generate commands and
watch events on the Simply Blue Command interface
• CRISP In System Programmer (ISP)
— Windows tool to update the on-chip firmware over the
command interface
• SB Smart Demo Application
— Windows tool for quick demo setup.
1.2.3 PC - Simply Blue Module Kit Setup
To set up the Simply Blue Commander:
1) Assemble the kit as shown in Figure 1-1.
2) Set ISEL1 and ISEL2 to UART at 115200 kbps or
921600 kbps, depending on the UART card in the PC.
Reference Table 2-16 on page 9 for details on setting
the UART interface.
3) Insert the kit CD. If the installation does not start auto-
matically, double click Setup.exe on the root of the CD
drive.
4) Click the Install Software button. Reference Figure 1-3
on page 5. This will install CRISP, documentation, SB
Smart and Simply Blue Commander. Please browse
the CD.
5) Shortcuts are installed at Start->Programs->Simply
Blue 2.0. Reference Figure 1-4 on page 6.
For usage of the Simply Blue Commander refer to the
“LMX982x Serial Port Module: Simply Blue Commander
User’s Guide”
1.2.4 CRISP In System Programmer (ISP) - Updating
Firmware
Updating the firmware is possible by using the CRISP tool
included on the CD-ROM. Kits are shipped with the current
revision of firmware, so it is not necessary to update the kit
immediately. Firmware updates will be released via the
Wireless Developer’s site or are available from local FAEs.
1) Assemble the kit as shown in Figure 1-1.
2) Launch CRISP from the installed short cuts. Start-
>Programs->Simply Blue 2.0->CRISP
3) Follow the CRISP User’s Guide instructions. The guide
must be followed closely.
If further assistance is required, contact your FAE or local
National sales representative.
1.2.5 SB Smart
Reference the SB Smart User Guide.
5V Power Supply
Null Modem Cable
PC
Speaker
Mic/
Audio In