Nortel Networks Application Server 53r 5300 00 - Manual (Page 57)

Reinstalling platform software 57
MCP Backup Tar Files
1) mcpPlatform.as5300-micro-s1.yyyy.mm.dd.hh.mm.
tar
2) mcpPlatform.as5300-micro-s2.yyyy.mm.dd.hh.mm.
tar
0) Cancel remote TAR file selection
10 Do one of the following:
From the MCP Backup Tar Files list, select the file to restore.
OR
Select 0 to cancel remote retrieval and return to remote retrieval
prompt.
Attention: Backup data is specific to each server. Only
restore platform data to the server from which the backup data
originated.
The Configuration Validation screen appears, listing the
networking settings as retrieved from the backup file.
11 Reply Y to accept the Configuration Validation summary.
OR
Reply N if the information displayed in the Configuration
Validation summary is incorrect or if you want to make changes.
If you select this option, you have the choice to start over and
retrieve a different backup file or step through and modify the
existing (embedded) backup information. You can refer to
"Configuring the networking, serial console redirection, and time
zone settings" (page 45)
for more information on these steps.
When the Configuration Validation information is accepted, a
second page of Configuration Validation information appears.
This summary contains the Network Time Protocol (NTP),
Syslog, and Audit Daemon settings.
The installer displays the following prompt:
Is this information correct?
12 Reply Y to accept the information.
OR
Reply N to go back and make changes. The installer advances
through the configuration settings one at a time. You can refer to
"Configuring the NTP, Syslog, and Audit Daemon settings" (page
47)
for more information on these steps.
Application Server 5300
Nortel AS 5300 Installation
NN42040-300 01.04
4 November 2008
Copyright © 2007-2008 Nortel Networks
.