Nortel Networks 4065R - Manual (Page 10)

Setting up the handset
10
Your handset can be used to make and receive calls only after you
charge the batteries.
Installing the battery pack
You must install the battery pack before you can use your handset.
1. Make sure the handset is switched off. Place the handset with the
display downwards on a flat surface.
2. Push the battery pack into the casing, as shown in Figure 1 (1).
3. Press the battery pack down until it locks, as shown in Figure 1 (2).
CAUTION
•
Use only the plug-in AC adapter and battery type
supplied, and use only approved accessories.
• Ensure the mains voltage of the adapter matches the
local mains voltage.
• Do not use AC adapters that are visibly damaged
(cracked or broken housing), and keep the ventilation
slits on the AC adapters free of obstruction.
WARNING
•
Do not use any batteries except those provided or
authorised by Nortel.
• Do not charge the batteries unless you use the
supplied charger and the proper batteries.
• Do not replace the batteries in potentially explosive
environments, such as rooms where flammable
liquids or gases are present.
• Do not dispose of batteries in a fire. Recycle or
dispose of batteries in accordance with local
regulations.