Niles Audio RFG - Manual (Page 13)

NIlEs AUDIO CORPORATION – 1-800-bUY-hIFI – 305-238-4373
11
WIRInG conSIdeRAtIonS
The RFG requires two different types of wires run, based on set-up and system design:
1) cAt-5 cABle
A CAt-5 cable is used to connect the RFG to either the ht-MSu, MultiZone
receiver or to a keypad. this cable must be terminated with RJ45 connectors
using t568A protocol as shown in
Figure 8 .
2) poweR cABle
A power supply is needed when the RFG is set-up as an independent Repeater
Base or Wireless Keypad. A niles FG01035 Power Supply (sold separately) is
used and connected using the barrel connector.
Figure 8. t568A wire termination
1 = GReen/white
2 = GReen
3 = oRAnGe/white
4 = Blue
5 = Blue/white
6 = oRAnGe
7 = BRown/white
8 = BRown