Nortel Networks NN46110-602 - Manual (Page 118)

118 Chapter 5 Packet capture
NN46110-602
Tunnel capture parameters
Capture objects for tunnels have several unique parameters. The following
example creates a tunnel object called bot1, navigates to Capture Configuration
mode, and displays the commands for tunnel objects. The commands in bold are
the commands that are available only for tunnel objects. For more information
about tunnel capture objects, see
“Tunnel captures” on page 106 .
CES# capture add bot1 tunnel
CES# capture bot1
CES(capture-tunnel)# ?
Packet capture mode
direction Captures in one direction
exit Exits capture mode
filter Applies interface traffic filter to capture
only matching traffic
length Specifies how many octets to capture for
every packet
no Disables features and settings
persistent Restarts capture on session disconnect
remoteip Captures sessions from this IP address
trigger Enables triggers
type Captures only sessions of specific type
userid Captures sessions from this user
wrapping Continues capturing when buffer gets full
CES(capture-tunnel)#
For the syntax of any command, see the Nortel VPN Router Using the Command
Line Interface (NN46110-507).