Northern Industrial Tools 10000 BDG - Manual (Page 33)

Operation (cont’d)
33
o Removing all fuel from the tank and carburetor
OR
o Adding fuel stabilizer to the fuel (following manufacturer’s
instructions)
Fuel stabilizer steps:
1. Ensure fuel tank is full.
2. Add fuel stabilizer to fuel tank.
3. Run engine at least 10 minutes after adding stabilizer to
allow it to enter the fuel system.
4. Shut off engine
5. Disconnect spark plug wire and remove spark plug
6. Add one teaspoon oil through spark plug hole
7. Place rag over spark plug hole and turn starter (or pull the
recoil) a few times to lubricate the combustion chamber.
8. Replace spark plug, but do not reconnect the spark plug wire.