Nortel Networks 2332 - Manual (Page 5)

5
Nortel WLAN—Series 2332 Access Points Quick Installation
NETHERLANDS, POLAND, PORTUGAL, ROMANIA, SLOVAKIA, SLOVENIA, SPAIN, SWEDEN, UNITED
KINGDOM, ICELAND, LICHTENSTEIN, NORWAY, SWITZERLAND
The WLAN Access Point 2332-E1 and related Series 2332 access points communicate with a Nortel Networks WLAN -
Security Switch using a standard CAT-5 (Category 5) or higher 10/100 Mbps twisted pair Ethernet cable to provide
wireless local area networking (WLAN) capabilities. The WLAN Access Point 2332-E1 and related Series 2332 access
points include one 802.11a and one 802.11b/g radio and two 802.11a and two 802.11b/g omnidirectional internal
antennas. In addition, the 2332-E1 and related Series 2332 access points can use optional factory-supplied external
omnidirectional and/or directional high-gain antennas, one per the 802.11b/g and one per the 802.11a radios, as
described in the external antenna section of the WLAN Series 2332 Access Point Installation Guide. When using the
external antennas, connect them to the reverse-polarity R-SMA connectors located on the side of the WLAN 2332-E1 or
related Series 2332 Access Point.
Declaration of Conformity
Marking by this symbol
indicates compliance with the Essential Requirements of the R&TTE Directive of the European Union (1999/5/EC).
This equipment meets the following conformance standards:
Safety: EN 60950-1:2001 + A11:2004
EMC: EN 55022:2006, EN 55024:1998 + A1:2001 + A2:2003, EN 301-489-1 v1.6.1, EN 301-489-17 v1.2.1,
CISPR22:1997, CISPR24
Including: EN 61000-3-2, -3-3, -4-2, -4-3, -4-4, -4-5, -4-6 and -4-11. The product is also licensed as required for
additional country specific standards as required for the International Marketplace.
Radio: EN 300-328 v.1.7.1 (2006-10) & EN 301-893 v.1.3.1 (2005-08)
NOTE: The 2332-E1 and related Series 2332 access points meet all of the technical specifications of
EN 301-893 v1.3.1 for operation in the 5.0 GHz bands, except the DFS requirements. The 2332-E1 and associated
Series 2332 access points were tested to and are compliant with the DFS requirements of EN 301-893 v1.2.3.
Electromagnetic compatibility and Radio spectrum Matters (ERM); Wideband transmission systems; Data
transmission equipment operating in the 2,4 GHz ISM band and using wide band modulation techniques and
Broadband Radio Access Networks (BRAN); 5 GHz high performance RLAN. Certifications are harmonized to the
EN standards covering essential requirements under article 3.2 of the R&TTE Directive. Compliance includes
testing with antennas as specified in attached table.
SAR: EN 50385:2002
!