NEC MT830 - Manual (Page 16)

16
INTRODUCTION 30
29
Remote Control Precautions
• Do not look into the laser pointer while it is on.
• Do not point the laser beam at a person.
• When the cable is connected to the remote control, it will not work
in the wireless mode.
• Handle the remote control carefully.
• If the remote control gets wet, wipe it dry immediately.
• Avoid excessive heat and humidity.
• If you will not be using the remote control for a long time, remove the
batteries.
• Do not mix new and old or different types of batteries.
19 Slide Button
Press (+) to advance the next file or slide and (-) to return to the
previous file or slide. (the optional MT Viewer board required)
20 Magnify Button
Use the (+) or (-) button to adjust the image size up to 400%.
When the Pointer is displayed, the magnified image is displayed at
the center of the Pointer.
When the Pointer is not displayed, the magnified image is displayed
at the center of the screen.
21 Keystone Button
Press the (+) or (-) button to correct the keystone (trapezoidal)
distortion, and make the image square.
22 Focus Button
Press the (+) or (-) button to adjust the focus.
23 Zoom Button
Press the (+) button to zoom in and the (-) button to zoom out.
24 Remote Jack
Connect your remote control cable here for wired operation.
NOTE: You cannot use Menu and Pointer at the same time.
OFF ON
PC CARD
VIDEO
RGB 1
MENU
R-CLICK/CANCEL
LASER
SLIDE VOLUME
S-VIDEO
POINTER
MAGNIFY
PIC-MUTE FREEZE
RGB 2
+
–
+ –
+
–
+
–
FOCUS KEYSTONE ZOOM
+
–
+
–
+
–
POWER
19
20
21
22
23
24