NEC MT830 - Manual (Page 26)

26
PC CONTROL MOUSE OUTPUT REMOTE
CONTROL
INPUT
AUDIO R G B I N P U T 2 AUDIO R G B I N P U T 1
AUDIO R G B M O N I T O R O U T P U T R L / M O N O
I N P U T A U D I O S – V I D E O
R L / M O N O
I N P U T A U D I O V I D E O
Wiring Diagram
Remote Control Guideline
1. Plug the serial cable with the mouse output port of the projector into your computer's mouse port and restart your computer to gain remote
mouse control.
2. When using the remote control's built-in infrared mouse on a laptop computer, the laptop's mouse, trackball or trackpad will be disabled.
Disconnect the serial cable from the mouse output port and restart your computer to regain trackball or trackpad mouse control.
3. If the screen goes blank while using your remote control, it may be the result of the computer's screen-saver or power management
software.
4. If you accidentally hit the OFF button on the remote control, wait one full minute before turning the projector on again.
INSTALLATION
49
50
Document Camera
Macintosh or Compatibles (Desk top type)
IBM VGA or Compatibles
Monitor
VCR, DVD Player or LaserDisc Player
Mouse adapter (For Macintosh)
Mouse adapter (For IBM PS/2)
Pin adapter for Macintosh (supplied)
Signal cable (supplied)
To mini D-Sub 15-pin connector on the LCD Projector.
To video, S-video, and
audio inputs on the LCD
Projector.
Remote cable