English troubleshooting – Remington EL-8: 107624-01 User Manual

Page 17

Advertising
background image

17

107705

www.desatech.com

ENGLISH

TROUBLESHOOTING

WARNING: Unplug chain saw from

power source before servicing. Severe injury

or death could occur from electrical shock

or body contact with moving chain.

Note: For additional help, visit DESA Specialty

Products’™ technical service web site at

www.

desatech.com.

OBSERVED FAULT

Saw runs, but does not cut

Saw does not cut unless heavily

forced. Cutting produces only saw-

dust with few large chips

Saw runs slow. Saw stalls easily

Motor of saw does not run when you

squeeze trigger

Motor of saw runs, but chain does

not move

Chain does not get oil

Chain comes off guide bar

Saw smokes

Saw leaks oil

POSSIBLE CAUSE

Chain assembled backwards on

guide bar

Chain is dull

Low power supply voltage

1. Switch lockout not pushed for-

ward in to release trigger

2. Extension cord connections loose

3. Open line fuse or circuit breaker

4. Worn out motor brushes

5. Open wiring circuit on saw

Gear train failure

All Models

1. Clogged oil slot in guide bar

2. Oil is too thick

Models with Automatic Oiler

1. Vent in oil cap clogged

2. Filter in oil reserVoir clogged

3. Pump damaged, do not use saw

1. Chain is loose

2. Guide bar and chain not as-

sembled correctly

Saw damaged. Do not use saw

Oil cap is not secure

REMEDY

See Assembly, pages 7 and 8

See Sharpening Saw Chain, pages

14 and 15

Extension cord wire size too small.

See Extension Cords, page 10

1. Push switch lockout forward

before squeezing trigger

2. Check cord connections

3. Check line fuse or circuit breaker

4. See authorized service center

5. See authorized service center

See authorized service center

1. Remove guide bar and clean oil

slot

2. Use correct weight of oil. See

Filling Oil Tank,

page 9

1. Remove cap and clean vent hole

2. Remove filter in oil reserVoir and

clean

3. See authorized service center

1. Tighten chain. See Saw Chain Ten-

sion Adjustment,

pages 8 and 9

2. See Assembly, pages 7 and 8

See authorized service center

Tighten oil cap.

Note: Empty oil

tank when not in use

Advertising
This manual is related to the following products: