Renesas M3028BT-EPB - Manual (Page 75)

M3028BT-EPB User’s Manual 4. Hardware Specifications
REJ10J1459-0200 Rev.2.00 Sep 16, 2006
4.5 Notes on Using This Product
Notes on using this product are listed below. When debugging the MCU using this product, be careful about the following
precautions.
IMPORTANT
Note on the Version of the Emulator Debugger:
z Be sure to use this product with one of the following emulator debuggers.
(1) M16C R8C PC7501 Emulator debugger V.1.01 Release 00 or later
(2) M3T-PD30F V2.20 Release 1 or later.
Notes on Downloading Firmware:
z Before using this product for the first time, it is necessary to download the dedicated firmware (control software
built into the PC7501). Please note that, to do this, it is necessary to start up the PC7501 in maintenance mode.
For firmware download procedures, see "2.7 Downloading Firmware" (page 27). Once the firmware has been
downloaded, the product can be used by simply turning on the power.
z Do not shut off the power while downloading the firmware. If this happens, the product will not start up
properly. If power is shut off unexpectedly, redownload the firmware.
z Download the firmware with the user system not connected.
Notes on Self-check:
z If the self-check does not result normally (excluding user system errors), the emulation probe may be damaged.
Then contact your local distributor.
z Run the self-check with the user system not connected.
Note on Quitting the Emulator Debugger:
z To restart the emulator debugger after it ends, always shut power to the emulator module off once and then on
again.
Note on Display of MCU Status:
z "MCU status" you can refer to in the MCU tab of the MCU Setting dialog box of the emulator debugger shows
pin levels of the user system. Make sure that proper pin levels are specified according to the mode you use.
When single-chip mode is used:
CNVss:
Low
Page 73 of 86