Raymarine Raystar 120 - Manual (Page 11)

Chapter 2: Installation 5
2
In
stal
lati
on
Chapter 2: Installation
The sections in this chapter explain how to install the Raystar 120/112LP
receivers:
CAUTION:
Before starting installation ensure you have the correct unit for your
application.The Raystar 120/112LP compatibility table on page 18
identifies the correct version of the Raystar 120/112LP Receiver for
compatible Raymarine, Autohelm and Apelco units. Raymarine
cannot be held responsible for incorrect operation due to incorrect
unit specification. Always state which model you have when
contacting Raymarine or a registered service agent.
2.1 Planning the installation
Before starting to install the Raystar 120/112LP, read through the
following information about:
• Parts supplied
• Cabling guidelines
• Electromagnetic compatibility (EMC) installation guidelines
Parts supplied
The Raystar 120/112LP package contains the following items:
1. Low profile GPS Receiver, with10 m (33 ft) cable
2. Flush mount gasket
3. Mounting studs (x2) and thumb nuts (x2)
4. Pole mount kit *
5. Owner’s Handbook (includes warranty documents)
Note: * If you intend to mount the receiver on a pole, you will need to
obtain a suitable pole with 1 inch 14 TPI thread.
Section Page
Section 2.1, Planning the installation 5
Section 2.2, Selecting a suitable location 8
Section 2.3, Mounting the receiver 9