Raymarine Raystar 120 - Manual (Page 15)

Chapter 2: Installation 9
2
In
stal
lati
on
2.3 Mounting the receiver
When you have selected a suitable location, follow the relevant
installation instructions for Pole mounting or Surface mounting.
Pole mounting
Note: You will need to obtain a suitable pole with 1 inch 14 TPI thread.
1. Securely attach the pole mount base to a suitable pole or rail mount
bracket.
2. Pass the cable through either:
A: the center hole of the pole mount base, or
B: the cable exit hole alongside the center hole, or
C: the side exit channel
Note: If you intend to use the side exit channel, remove the two plastic
tabs obstructing the channel. If you do not remove these tabs before
using the cable channel, you could damage the cable.
3. Check the cable is positioned correctly, then secure the receiver to the
pole mount base using the two screws provided.
.
Figure 2-1: Pole mounting
D5898-1
A
B
C