Rosen Entertainment Systems M10 - Manual (Page 14)

14
Rosen M10 Owner’s Manual
Adjust headphones
here
Volume Knob
Power LED
Power ON/Off
switch
USING WIRELESS HEADPHONES
The system is compatible with wireless infrared (IR) single-channel
headphones (AC3003). These headphones receive a signal from an
IR transmitter built into the M10. These headphones allow rear-seat
passengers to listen without using the vehicle speakers.
To turn the headphones on and off, push the Power ON/OFF button
on the right ear piece. The Power LED on the left ear piece indicates
when headphone power is on. Power turns off automatically after
three minutes of no audio, in order to preserve battery life.
To adjust the headphone volume,
rotate the thumb wheel on the
headphones.
To adjust the headphone size for
differently-sized heads,
slide the top as needed.
The M10 IR transmitter has two output channels, A and B. Using A and
B, the M10 can transmit two different audio programs at the same
time. When using optional Rosen AC3072 dual-channel headphones,
listeners can switch between Channels A and B. For more, see P. 19.
When the M10 is installed as a second display for a Rosen A10
system, the A10 is the infrared transmitter for both Channels A and B,
and the M10 infrared transmitter is disabled.
REPLACING HEADPHONE BATTERIES
The wireless IR headphones require two AAA batteries. To replace
the batteries, slide off the battery compartment door on the right
earpiece and insert batteries, as shown. Make certain that the battery
orientation matches the marks inside the battery compartment.
USING OPTIONAL WIRED HEADPHONES
There is a jack for wired headphones on the forward edge of the
unit, under a removable cover. When using optional wired head-
phones, only use headphones with a volume control, since the
system has no volume adjustment.
Mini-stereo Headphone Jack