Radio Shack 15-2143 - Manual (Page 8)

15 14
Using the Sleep Timer
Code Identification Feature
The Code Identification Feature allows you to identify
the three digit library code stored under your device key.
For example, if you want to find out what three-digit
code is stored under your TV device key, follow the six
steps below:
1. Press and hold the CODE SEARCH button until the
red indicator stays on. Release the CODE SEARCH
button.
2. Press and release the desired mode button (TV,
VCR , etc.). The red indicator blinks, and then stays
lit.
3. Press and release the CODE SEARCH button. The
red indicator blinks off.
4. To find the first digit for the code stored under the
mode button you pressed in step 2, press each
numeric key from 0-9 in turn. When the red indicator
blinks off the number you pressed is the first digit
for the code you are searching for.
5. To find the second digit, repeat step 4. This time
when the red indicator blinks off, this is the second
digit.
6. Repeat step 4 again to find the third digit.
Code Identification
1, 3.
2.
4, 5, 6.
The Sleep button accesses the sleep function of your
TV if it has that feature. If it does not, you can enable
the remote to turn off your TV after a period of 1 to 99
minutes, as shown below. The remote must be in TV
mode to set a Sleep Timer. This feature works even if
your TV does not have a sleep feature.
1. Press and release the TV Mode button.
2. Press and hold the SLEEP button until red indicator
remains on (occurring after approx. 2-3 seconds).
3. Release the SLEEP button.
4. Press and release the numeric buttons (01-99) for the
time required. The red indicator blinks off to indicate
button press acceptance and remains off after the
second button press.
5. Leave your Remote pointing towards
the TV with an unobstructed path.
To cancel the Sleep Timer, press and hold the SLEEP key
for 2-3 seconds until the red indicator blinks or press
and release the
POWER button in TV Mode.