Roland SP-404SX - Manual (Page 20)

20
7. Produce.sound.on.the.device.that’s.connected.to.the.SP-404SX,.and.Press.the.[REC].button.when.you.want.to.
start.sampling .
[REC] button will light, and
sampling will begin .
NOTE
Never turn off the power while sampling is in progress . If you turn off the power, not only the sample being recorded but
also other samples may also be destroyed .
8. When.you.want.to.stop.sampling,.press.the.[REC].button .
[REC] button will go out, and
sampling will end .
If the display indicates “
F U L
”
In the following cases, the display will indicate “ F U L ,” and sampling will end automatically .
• When there is no remaining free space on the SD card
• When the sample currently being recorded exceeds 2 GB (approximately 180 minutes in stereo)
9. Press.the.pad.[1].to.play.back.the.sound.you.just.sampled .
If the sample included an unwanted portion
If there is unwanted sound or silence at the beginning or end of the sample, you can make settings so that only the
desired portion will be heard .
For details, refer to”Adjusting the Playback Region of a Sample” (p . 27) .
If you want to re-record the sample
Delete the sample as described in “Deleting a Sample” (p . 21) on the following page, and then re-record the sample .