Radio Shack 43-3546 - Manual (Page 7)

U
si
ng Yo
ur
P
ho
ne
7
1. Press and hold FLASH until you hear a confirmation
tone.
2. To set the dial mode for pulse dialing, press # . Or to set
the dial mode for tone dialing, press /TONE .
A confirmation tone sounds to indicate the setting is
complete.
• If you are not sure of your dialing system, set for tone
dialing. Make a trial call. If the call connects, leave the
setting as is, otherwise set for pulse dialing.
• If your phone dialing system requires pulse dialing and
you need to send DTMF tones for certain situations
during a call, you may “switch-over” to tone dialing
(refer to “Tone Dialing Switch-over” on page 8).
USING YOUR PHONE
M AKING AND R ECEIVING C ALLS
A DJUSTING THE R INGER T ONE AND
V
OLUME
When the phone is in standby mode, press VOL repeatedly
to listen to the four ringer tones and volume combinations.
The phone keeps the last ringer tone setting selected.
Handset On Base Handset Off Base
Answer call
When the phone rings,
remove the handset
from the base (Auto
Talk). Press TALK, any
number key, /TONE,
or #.
Make call
1) Remove the handset
from the base and
press TALK.
Ô
2) The TALK/BATT LOW
flashes and turns on.
3) Listen for the dial
tone.
4) Dial the number.
1) Press TALK.
2) The TALK/BATT
LOW flashes and
turns on.
3) Listen for the dial
tone.
4) Dial the number.
Hang up Press END or return the handset to the base.
Redial
1) Remove the handset
from the base and
press TALK.
2) Listen for the dial
tone.
3) Press PAUSE/
REDIAL to dial the
last dialed number.
Ô
1) Press TALK.
2) Listen for the dial
tone.
3) Press PAUSE/
REDIAL to dial the
last dialed number.
Ringer Mute None
Press END when
ringing.
Ô
NOTES
Ô
• During a call, as you begin
to move your handset too far
from your base unit, noise
increases. If you pass the
range limits of the base unit,
your call will terminate within
one minute.
• The PAUSE/REDIAL key
redials the last number dialed.
• The redialed number can be up
to 24 digits long.
43-3556.fm 7 ページ ２００４年１月２８日 水曜日 午前１０時５２分