Regalo Safety Gate - Manual (Page 7)

Next, tighten the top 2 Adjustment Wheels by turning them counter-clockwise.
Again, make sure both sides are equal as you tighten. As you tighten the Adjustment
wheels you will notice the gap between the plastic gate door latch and the frame tube
is narrowing. As the gap continues to narrow continue turning the upper Adjustment
Wheels until the frame tube engages in the slot in the plastic gate door handle. Leave
a 1/16” gap between the frame tube and the plastic gate door latch as shown in
Diagram F. IMPORTANT: The frame tube MUST NOT touch the Plastic gate door
latch. If it does touch you have turned the Adjustment Wheels a few too many turns.
To correct this simply turn the upper Adjustment wheels clockwise a few turns until
you have a 1/16 inch gap. Your gate is now ready to use.
(7)
Important: Keep these
instructions for future
reference
Di agram F .
th
Gate Instructions
T h re a d e d S p i n d l e R o d
Flat Plastic End
Adiustment
Wheel
Frame Tube
1/16