Radio Shack CT-502 - Manual (Page 63)

63
6. Within 8 seconds, press then enter the 2-digit mem-
ory location number (01–50) where you want to store the
card sequence, or press
to automatically select the
first unused memory location. Alpha or STO appears
to prompt you for the next step.
Note: If you are unable to complete this step within 8
seconds, the display goes blank. Press
to
recall the display and try again.
7. Enter the name to describe this calling card sequence
( XYZ LONG DIST , for example), then press . To
proceed without storing a name, simply press .The
phone displays the memory location number you
selected to confirm the entry.
Placing a Call Using a Stored Calling
Card Sequence
1. Recall the calling card sequence from memory, then
press to dial the call. (Or, if you stored the sequence
in any memory from 02–09, simply hold down that num-
ber for one-touch dialing.)
Enter Number appears.
This prompts you to enter the area code and phone num-
ber you want to call.
2. Enter the area code and phone number you want to call,
or recall that number from memory, then press . The
phone begins dialing the call.
Note: When you press the keys, the phone sounds dif-
ferent tones than the ones it normally makes.
3. When you hear the prompt, press to dial the calling
card PIN (or other information you stored in the calling
card sequence).
Note: Repeat this step for each sequence you stored.
STO
END STO
STO
STO
SND
SND
SND
17-1111.fm Page 63 Wednesday, July 21, 1999 2:23 PM