Ryobi ELL0001 - Manual (Page 10)

10 11
NOTE: The multi-function base is not used
when mounting by vacuum grip.
n Place the laser level on the surface you
want it secured to and push in slightly to
seal.
n Continue to hold the laser level against the
surface while pressing the on/off switch.
n Release the laser level when you hear a
change in motor sound.
NOTE: To release the vacuum seal, turn the
laser level’s power off. For fast release, press
the protrusion on the back of the unit. Pulling
the laser level off the wall without releasing the
vacuum could damage the tool.
The laser will automatically shut off 15 min-
utes prior to battery failure, but the motor will
remain on. Press the on/off switch to power
down the unit and replace the batteries.
TURNING ON/OFF
See Figure 4.
Press the switch located on the right side of
the laser level to turn it ON and OFF. Always
wait for at least 5 seconds between stopping
and restarting the laser level.
OPERATION
Fig. 4
Fig. 5
POSITIONING THE LASER LEVEL
The laser level has several positioning options
available to suit the needs of your project.
For a quick reference or alignment between
two points, the laser level can be hand held
or placed on a horizontal surface.
USING THE AIR-GRIP VACUUM
See Figure 5.
The laser level’s vacuum grip technology al-
lows attachment to most smooth surfaces.
PRESS TO
TURN OFF
ON/OFF
SWITCH
ON/OFF
SWITCH
PRESS TO
TURN ON