Roland KC-60 - Manual (Page 7)

7
Panel Descriptions
7. Power Indicator
This indicator illuminates when the power is on.
8. POWER Switch
This switches the power on and off.
* Always be sure to lower the volume on the KC-60 and any
connected equipment to 0 whenever turning the power on or off.
* This unit is equipped with a protection circuit. A brief interval
(a few seconds) after power up is required before the unit will
operate normally.
Slight pop noise may come from the speakers when the power is
switched on, but this does not indicate a problem.
* Refer to p. 9 for the order in which to turn the power to
connected devices on and off.
9. AUX IN Jacks
These are RCA phono type input jacks.
You use these to connect equipment such as CD and MD
players, and have them sound along with the equipment
connected to channel 1 through channel 3.
They accept level input of -10 dBu.
* To adjust the volume level of equipment connected to the AUX
IN jacks, use the controls on such equipment.
* Even though the input signal may be in stereo, the signal is
mixed internally to a mono signal.
10.LINE OUT Jack
Connect mixers, recorders, and other such equipment here.
This output jack provides +4 dBu line level output.
* The MASTER CONTROL knobs (the LOW, HIGH, and
VOLUME controls) do not affect the output from LINE OUT.
11.SUBWOOFER OUT Jack
This lets you play even more powerful bass by connecting a
powered subwoofer.
Provides full-range output, at an output level +4 dBu.
You can use the MASTER CONTROL knobs (LOW, HIGH,
and VOLUME) to adjust the tone and volume level of the
signals output from SUBWOOFER OUT.
* No signals are output from SUBWOOFER OUT when
headphones are connected.