RedMax HEZ2460S - Manual (Page 12)

US-12
HEZ2460S/HEZ3060S
8. Operation
The RedMax stick edgers are designed
for edging lawn in gardens, parks,
roadsides and so on.
Before starting the engine, take the
operating position and adjust the handle
position and the wheel height as
necessary.
■ ADJUSTING WHEEL HEIGHT
1. Loosen the wing nut and change the
wheel height to obtain desired cutting
depth. (OP1)
(1) Deep cut
(2) Shallow cut
(3) Wing nut
2. After adjusting the height, tighten the
wing nut securely.
Tightening Torque:
51~68in-lbs (6~8N.m.)
• Never adjust wheel height with the
engine running.
WARNING
OP2 (1)
(2)
(3)
OP1
(2)
(3)
(1)
OP3
(1)
(3)
(a)
(b)
(2)
OP4
OP5
■ STARTING ENGINE
The cutting head will start rotating
upon the engine starts.
1. Rest the unit on a flat, firm place. Keep
the cutting head off the ground and
clear of surrounding objects as it will
start rotating upon starting of the
engine.
2. Push the primer pump several times
until overflown fuel flows out in the
clear tube. (OP2)
3. Move the choke lever to the closed
position. (OP3)
(1) choke lever
(2) close
(3) open
4. Set the stop switch to the "RUN"
position. Place the unit on a flat, firm
place. Keep the cutting head clear of
everything around it. (OP4)
(1) stop switch
(2) RUN
(3) STOP
(a) lockout lever
(b) throttle trigger
5. Firmly grasp (a) and (b) with left hand
(OP4), pull the starter knob quickly until
engine fires. Release throttle trigger
after engine starts. (OP5)
• Avoid pulling the rope to its end or
returning it by releasing the knob. Such
actions can cause starter failures.
6. Move the choke lever downward to
open the choke. And restart engine.
(OP3)
7. Allow the engine to warm up for several
minutes before starting operation.
IMPORTANT
WARNING