RCA RP-9349 ES - Manual (Page 6)

6
SETTING UP THE SYSTEM
Connecting & placing
the speakers
Each speaker has its own connection terminals on
the back of the system, so connect the wires from
each speaker to one set of terminals. When
connecting the speakers, make sure that the bare
end of each wire makes contact with the metal grips
inside the terminal. There are connections provided
for main and surround speakers.
1. Press down on the tab to open the red terminal
and insert the red wire (+) into the red terminal.
2. Press down on the tab to open the black terminal
and insert the black wire (–) into the black
terminal.
WARNING: Be sure to follow these instructions
carefully. The system can be damaged if speakers
are improperly connected.
The speakers should be set between 6 and 10 feet
apart. Putting the speakers any closer or any farther
apart may result in distorted sound.
The speakers should also form a 45 degree angle to
the central listening point in the room, creating a
triangle of listening enjoyment.
Connecting the
Antennas
The AM and FM wire antennas connect to the FM
ANTENNA terminals and AM terminal on the
system’s back panel, and must be connected for
clear reception. Connect the antenna wires similar
to the way you connected the speakers.
After connecting the antennas, extend them to their
full length; then you can adjust their position for
better reception when you are listening to the
radio.
+ –
RED BLACK
FM
AM
LOOP
ANTENNA
FM
AM