Using the looper, Recording a phrase, Playing back the recorded phrase – Roland CUBE-80X User Manual
Page 19: P. 17), Refer to “using the looper” (p. 17)
Español
Italiano
Français
Deutsch
English
Português
Nederlands
17
Using the LOOPER
This lets you record a phrase you play, and play it back any
number of times. You can also use it to overdub a recorded
phrase.
On this unit, this feature is called the “LOOPER.”
You can also operate the LOOPER function using an optionally
available footswitch pedal.
*
The recorded phrase is deleted when the unit is turned off.
*
Unauthorized recording, distribution, sale, lending, public performance,
broadcasting, or the like, in whole or in part, of a work (musical
composition, video, broadcast, public performance, or the like) whose
copyright is held by a third party is prohibited by law.
*
Never use this unit for any purpose that may infringe on a copyright
held by a third party. Roland assumes no responsibility for any
infringement of third-party copyright arising through your use of this
unit.
1.
Set the DELAY/LOOPER knob at LOOPER.
Set the knob at the
maximum setting. With
the knob at the
maximum, the phrase will
be played back at the
same volume as when it
was recorded.
2.
Press the TAP switch or depress the TAP/REC/
PLAY/DUB footswitch.
When you press the TAP
switch, it begins flashing in
red and the unit enters
recording standby.
If instead you depress the TAP/
REC/ PLAY/DUB footswitch, the
TAP switch lights in red, and
recording starts immediately.
i
3.
Start playing the guitar.
If the unit is in recording standby, the TAP switch lights up
and recording starts.
4.
To end recording, press the TAP switch or
depress the TAP/REC/PLAY/DUB footswitch
pedal.
The TAP switch lights in green and the recorded
performance is played back.
5.
Pressing either the TAP switch or the TAP/
REC/PLAY/DUB footswitch twice in rapid
succession stops playback.
The TAP switch flashes green.
*
You can also stop this by turning the DELAY/LOOPER knob to a position
other than LOOPER.
*
The maximum recording time is approximately 40 seconds. When the
maximum recording time is reached, recording automatically stops and
playback starts.
1.
While the TAP switch is flashing green, press
the TAP switch or depress the TAP/REC/PLAY/
DUB footswitch pedal.
The TAP switch lights in green and loop playback starts
from the beginning of the phrase.
2.
Adjust the volume for the phrase.
You can adjust the volume level of phrase playback by
adjusting the position of the DELAY/LOOPER knob.
3.
Pressing the TAP switch twice in rapid
succession stops playback.
The TAP switch flashes green.
Recording a Phrase
Flashes red
Lights red
Playing Back the Recorded Phrase
cube-80x.book 17 ページ ２００８年１２月１２日 金曜日 午後６時７分