Ryobi DP101 - Manual (Page 11)

11
WARNING:
Before adjustment, disconnect the drill press from the
power source.
TABLE ADJUSTMENTS
Adjusting the Table Height
See Figure 10.
To adjust table, hold the table with one hand and loosen the
table lock handle. Rotate the table crank handle to lower or
raise the table. Clockwise raises the table; counterclockwise
lowers it. Position the table in the desired position and
retighten the lock handle.
Fig. 9
ASSEMBLY
ADJUSTMENTS
8. Attach the three feed handles by screwing them into the
threaded holes in the hub.
9. Using the pre-drilled holes in the base, mount your drill
press securely on a sturdy surface such as a work stand,
workbench or counter top.
See Figure 9. If your drill press
is to be used in a portable application, it is recommended
that you fasten it permanently to a mounting board that
can be easily clamped to a workbench.
WARNING:
Do not connect to power supply until assembly is complete.
Failure to comply could result in accidental starting and
possible serious injury.
Once securely mounted on a sturdy surface, check the
following:
■ Check for vibration when the motor is switched ON.
Adjust and retighten the mounting hardware as
necessary.
■ Check the table assembly to assure smooth movement
up and down the column.
■ Check to assure that the spindle shaft moves smoothly.
MOUNTING
BOLTS
Fig. 10
TABLE CRANK HANDLE
TABLE LOCK
HANDLE