Ryobi DP101 - Manual (Page 9)

9
LOOSE PARTS
1. Head Assembly
2. Column
3. Table Assembly
4. Table Lock Handle
5. Base
6. Feed Handles (3)
7. Chuck Key
8. Pulley Housing Knob
9. M5 Pan Head Screw
10. M8 1.25 Hex Bolts (4)
11. Hex Wrench
12. Table Crank Handle
13. Gear Rack
14. Worm Gear
15. Column Collar
16. Chuck
17. Base Collar
18. Scale Set Handle
19. Operator’s Manual (not shown)
5
16
18
1
2
3
4
6
7
8
9
10
11
12.
13
14
15
17
Fig. 3
UNPACKING
1. Carefully remove all parts from the shipping carton.
2. Do not discard the packing material until you have
identified all the parts in the parts list.
3. If all parts have been included, proceed to assembly.
4. If you are missing a part, contact your dealer to obtain it
before attempting to assemble the tool.
5. Examine all the parts to make sure no breakage has
occurred during shipping. Any damaged or missing part
should be replaced before attempting to use the tool.
WARNING:
Do not allow familiarity with your drill press to make you
careless. Remember that a careless fraction of a second
is sufficient to inflict severe injury.
WARNING:
Do not attempt to assemble the drill press, plug in the
power cord, or turn on switch if any parts are damaged or
missing. Failure to heed this warning could result in serious
personal injury.