Rangemaster U102210-04 - Manual (Page 23)

23
Fit the levelling tool on the rectangular adjuster as
shown below.
LOWER THE FRONT ROLLER by doing 14 complete
(360°) turns clockwise. (This means turning and
removing the levelling tool 56 times).
Now LOWER THE TWO REAR ROLLERS.
First fi t the levelling tool on the hexagonal adjusting nut
as shown below.
Make 10 complete (360°) turns clockwise. (This means
turning and removing the levelling tool 20 times).
Make sure you lower BOTH REAR ROLLERS. There are
two adjusting nuts, one for each roller, at both the front
bottom corners of the cooker.
Carefully push the cooker backwards close to its fi nal
position leaving just enough space to get behind it. Take
care not to damage the power cable.
Do not use the door handles or control knobs to
manoeuvre the cooker. Remove the pack base tray.
Levelling
You are recommended to use a spirit level on a shelf in
one of the ovens to check for level.
Place the cooker in its intended position taking care not
to twist it within the gap between the kitchen units as
damage may occur to the cooker or the units.
The rollers can be adjusted to level the cooker. To adjust
the height of the rear of the cooker use the levelling tool
supplied to turn the adjusting nuts at the front bottom
corners of the cooker.
Adjust the height of the front roller to level the cooker.
Turn clockwise to raise the cooker and anticlockwise to
lower.
When you are satisfi ed with the height and level raise
the front of the cooker by one turn of the front roller
adjuster. Screw down the front feet to meet the fl oor.
Screw the front roller adjuster anticlockwise to raise the
front roller so that the front of the cooker is supported
on the feet, not the front roller, to prevent accidental
movement of the cooker.
Leave the levelling tool on the adjuster with the handle
of the tool facing the rear of the cooker, so that the
customer can use it if they wish to move the cooker.
Replace the drawer by locating on side runners and
push in.
Electrical Connection
This appliance must be installed by a qualifi ed
electrician to comply with the relevant Institute of
Electrical Engineers (I.E.E.) regulations and also the
local electricity supply company requirements.
WARNING: THIS APPLIANCE MUST BE EARTHED
Note
The cooker must be connected to the correct electrical
supply as stated on the voltage label on the cooker,
through a suitable cooker control unit incorporating
a double pole switch having a contact separation of
at least 3mm in all poles. This cooker must not be
connected to an ordinary domestic power point.
The cable size used should be between 6mm 2 and
10mm 2 , twin and earth.
Access to the mains terminal is gained by removing the
electrical terminal cover box on the back panel.