Radio Shack 43-3908 - Manual (Page 11)

Care
11
If you still have problems, disconnect the phone. If other
phones on the same line work properly, the fault is in this
phone or its installation. If you cannot find the problem, take
the phone to your local RadioShack store for assistance.
CARE
Keep the phone dry; if it gets wet, wipe it dry immediately.
Use and store the phone only in normal temperature
environments. Handle the phone carefully; do not drop it.
Keep the phone away from dust and dirt, and wipe it with a
damp cloth occasionally to keep it looking new.
SERVICE AND REPAIR
If your phone is not performing as it should, take it to your
local RadioShack store for assistance. Modifying or
tampering with the phone’s internal components can cause
a malfunction and might invalidate its warranty and void
your FCC authorization to operate it.
IMPORTANT INFORMATION
This telephone has been tested and found to comply with all
applicable UL and FCC standards.
FCC STATEMENT
Your telephone compiles with Part 68 of the FCC
Rules.Upon request, you must provide the phone’s FCC
registration number and REN to your phone company.
These numbers are on the base unit. Ô
Your phone is not intended to be used with party-line
systems. Connection to party line service is subject to state
tariffs. Contact the state public utility commission, public
service commission, or corporation commission for
information.
We have designed your phone to conform to federal
regulations, and you can connect it to most telephone lines.
However, each phone (and each device, such as a
telephone or answering machine) that you connect to the
telephone line draws power from the telephone line. We
refer to this power draw as the device’s ringer equivalence
number, or REN on the back of your phone.
If you use more than one phone or other device on the line,
add up all of the RENs. If the total is more than five (three in
Ô
NOTE
Ô
You must not connect your phone
to:
• coin-operated systems
• most electronic key telephone
systems
43-3908.fm Page 11 Thursday, December 19, 2002 3:12 PM