Radio Shack 43-3908 - Manual (Page 9)

Oper
atio
n
9
S TORING A N UMBER IN M EMORY
1. Lift the handset.
2. Press
MEMORY . TALK/BATT blinks.
3. Enter the number and any tone and pause entries (see
“Using Tone Services on a Pulse Line” on Page 8 and
“Entering a Pause” on Page 9). Ô
4. Press MEMORY again, then enter the memory location
number ( 0 – 9 ) where you want to store the number. A
tone sounds to indicate that the number is stored.
To replace a stored number, simply store a new one in its
place. Or, lift the handset and press
MEMORY twice. Then
press the memory location number ( 0 – 9 ) you want to clear.
A tone sounds.
E
NTERING A
P
AUSE
In some telephone systems, you must dial an access code
(9, for example) and wait for a second dial tone before you
can dial an outside number. You can store the access code
with the phone number. However, you should also store a
pause after the access code to allow the outside line time to
connect. To enter a 2-second pause, press
REDIAL/PAUSE .
You can add more pause entries for a longer pause.
D IALING A M EMORY N UMBER
To dial a number stored in memory, lift the handset and
press
TALK . TALK/BATT lights. When you hear a dial tone,
press MEMORY and enter the memory location number for
the number you want to dial.
To dial a number stored in memory location 1, press
SPEED
DIAL . You do not have to press TALK when you press
SPEED DIAL . Ô
C HAIN -D IALING S ERVICE N UMBERS
For quick recall of numbers for special services (such as
bank-by-phone), store each group of numbers in its own
memory location.
Dial the service’s main number first. Then, when prompted
to enter the number, press
MEMORY and enter the number
for the location where the additional information is stored.
T ESTING S TORED E MERGENCY N UMBERS
If you store an emergency service’s number (police
department, fire department, ambulance) and you choose to
test the stored number, make the test call during the late
evening or early morning hours to avoid peak demand
periods. Also, remain on the line to explain the reason for
your call.
Ô
NOTE
Ô
Storing a Number in Memory
• An error tone sounds and the
phone exits the programming
mode if you wait more than 30
seconds between keypresses.
• Each tone or pause entry uses
one digit of memory.
• If you try to enter more than 16
digits, the phone beeps 5 times
and exits the programming
mode. Start over at Step 2 and
enter no more than 16 digits in
Step 3.
Dialing a Memory Number
If you select an empty memory
location, the phone beeps 5 times.
43-3908.fm Page 9 Thursday, December 19, 2002 3:12 PM