RedMax POWER AUGER AG4300 - Manual (Page 11)

3. Operation
■ INSTALLING LEFT GRIP (F1)
• Screw in the left grip to the bracket provided on
the frame and tighten the lock nut securely.
(1) Left grip
(2) Bracket
(3) Lock nut
■ INSTALLING DRILL (F2)
1. Slide the ring clip and remove the lock pin from
the drill.
2. Put the drill onto the auger output shaft and
insert the lock pin. Cover it with the ring clip.
(1) PTO shaft
(2) Clip band
(3) Drill
(4) Pin
■ THROTTLE CABLE PLAY (F3)
• Check the throttle cable play and adjust to
1~2mm(.04~.08in.) as necessary.
(1) Lock nut
(2) Big
(3) Small
■ STARTING ENGINE
1. Fill fuel and tighten the cap securely.
2. Put the switch to “START” position. (F4)
3. Close the choke. (F5)
When restarting immediately after stopping the
engine, Ieave the choke open. (F5)
4. Push the primer pump until overflown fuel flows
out in the clear tube. (F5)
The pump operation is not necessary when
restarting the engine immediately after stopping it.
5. Push the start set button of the handle left
NOTE
NOTE
F1
F2
F3
F4
F5
11 