Maintenance – RedMax POWER AUGER AG4300 User Manual

Page 15

Advertising
background image

4. Maintenance

CYLINDER FINS (F16)
Dust clogging between the cylinder fins will cause
overheating of the engine. Periodically check and
clean the cylinder fins.

(1) Intake air cooling vent

SPARK ARRESTER (F17)
This engine is equipped with a spark arresting
screen at the exhaust port. Check periodically to
see if it is good condition, especially when your
machine is to be used on any forest covered, brush
covered, or grass covered unimproved land. In the
State of California the above is required by law
(Section 4442 of the California Public Resources
Code)

1. Remove the muffler guard and pry off the spark

arrester from the exhaust port.

2. Clean the metal screen with a wire brush. If

damaged, replace with new one.

(1) Muffler guard
(2) Spark arrester

GEAR BOX
Check oil level of the gear box every 50 hours of
use and change with new oil as necessary. (SAE
#80 - 90)

Recommended change interval
1st: After 50 hours of use
2nd and on: Every 100 hours of use

(1) Oiling port
(2) Oil drain port
(3) Oil level

CLUTCH
Disconnect the engine from the gear box and
check the clutch condition every 100 hours of use.
Wipe off oil attached to the drum and shoes, and
replace parts with a new one if found to be worn.

F16

F17

F18

15

Advertising