Rayming BTH-808 - Manual (Page 7)

www.rayming.com
BTH808_Users Guide_121504.doc
To make a call using voice dialing
1. Make sure the phone and the headset are on and within range of each other and then press the multifunction
button.
2. It may take a second to establish the wireless connection between the phone and the headset. During this
time, you might hear a repeated tone in the headset, but after the beep, you can begin to dial as you normally
would.
3. End the call by pressing the multifunction button.
To answer a call using the multifunction button
1. When the headset rings, press the multifunction button to answer.
2. End the call by pressing the multifunction button.
To reject a call
When the headset rings, press and hold the multifunction button until you hear a long beep.
USING VOICE COMMANDS
Voice commands are especially useful when you are using the headset. Examples of voice commands are
dialing, re-dialing, answering and rejecting calls. For more information on voice commands, refer to your phone’s
User Guide.
ADJUSTING THE VOLUME
You can adjust the headset speaker volume during a call, or the ring volume when you are not engaged in a call.
To adjust the volume
To increase the volume, press (+) .
To decrease the volume, press (-).
To turn off the microphone (mute mode)
During a call, press and release both (+) and (-) at the same time to turn off the microphone. A repeated beep is
heard while the microphone is turn off.
Press and release both (+) and (-) again to resume the conversation.
TRANSFERRING AUDIO FROM PHONE TO HEADSET
If you make a call with using your phone, you can transfer the audio to the headset if the headset is on, paired
with the phone and within range.
To transfer audio to the headset
During a call, press the multifunction button to transfer the sound to the headset. The headset beeps until the
sound has been transferred.
Note: To transfer the sound from the headset to the phone, refer to the phone’s User Guide.
LOST CONNECTION TO HEADSET
If the connection to the headset is lost during an ongoing call, press the YES key on the phone to transfer the call
to the phone, otherwise the call is disconnected after 30 seconds.