RIDGID SR-60 - Manual (Page 31)

Ridge Tool Company

Elyria, Ohio

U.S.A
www.seektech.com 29
SeekTech SR-60
Figure 45: Editing a User-Defined Frequency
(Note: Trash Icon for deleting Frequency appears when
Frequency is set to 0).
3. Use the arrow keys to move through the digits
and increase or decrease them.
4. When the frequency is correct, press the Select
Key to save the new value.
To delete a user-defined frequency:
1. Press the Menu Key to show the list of active
frequencies. Scroll down to the user-defined
frequency you wish to edit.
2. Press the Frequency Key . The user-defined
frequency window with the frequency you
selected will appear.
3. For each digit that is not set to zero, select the
digit and use the Down arrow key to reduce it to
zero.
4. When all digits in the frequency are set to zero,
the “trash can” icon will appear. Press the Select
Key . The user-defined frequency will be
deleted.
Figure 46: User-Defined Frequency Screen
Menus and Settings
Pressing the Menu Key brings up a series of choices
which let the operator configure the SR-60 as preferred
(see Figure 47).The menu is a context-sensitive list of
options. The entry point into the menu list is set to the
currently active frequency.
Auto Menu Exit Count-down Timer
While traversing the menu tree, a counter appears at the
bottom of the screen counting down. When it reaches
zero, it will automatically move back up one level of the
menu tree until it reaches the operating screen again. It
resets to nine with each key press, or each time it goes
up one menu level, until it reaches the operating screen.
Figure 47: Main Menu
In sequence from the top of the menu down, the Main
Menu presents the following items:
1. SimulTrace (512 Hz + 33 kHz) (If
activated).
2. Currently Available Sonde frequencies
(Checked-Active or not).
3. Currently Available Active Line Trace
frequencies (Checked-Active or not).
4. Currently Available Power (Passive Line
Trace) frequencies (Checked-Active or not).
5. Currently Available Radio Frequencies
(Low and High) (Checked-Active or not).
6. OmniSeek Mode
7. Depth Measurement Units Setting
8. Backlight Control.
9. Auto-Shutdown Control
10. LCD Contrast Control