Radio Shack ET-1105 - Manual (Page 13)

13
USING A HEADSET
You can make or answer calls with
hands-free convenience using an option-
al headset that has a
3 /
32
-inch (2.5 mm)
plug. We recommend RadioShack Cat.
No. 43-195, which is specially designed
for use with the ET-1105.
Follow these steps to use a headset.
1. Insert the headset’s plug into the
jack on the top of the handset.
2. Place the headset on your head with
the earpiece over either ear and ad-
just the microphone boom until it is
about even with your chin.
3. Hang the belt clip on your belt.
4. Make or receive calls as you would
normally (see “Making and Receiv-
ing a Call” on Page 14).
Notes:
• Connecting a headset disconnects
the handset’s earpiece and micro-
phone.
• If you place the handset on the base
to recharge it while the headset is
connected, be sure the handset
seats properly.
REMOVING THE BELT
CLIP
The belt clip on the back of the handset
lets you hang the handset on your belt for
easy portability. But to use the hanging
hole on the back of the handset to place
the handset on the wall-mounted base
face-up, you must remove the belt clip.
Insert a flat-blade screwdriver into either
side of the belt clip, then pull it off.
To replace the belt clip, insert either tab
of the belt clip into one of the handset’s
slots, then snap the other tab into hand-
set’s other slot.
43-1105.fm Page 13 Monday, August 30, 1999 1:57 PM