Roberts Radio R737 - Manual (Page 5)

Setting the clock
Ensure the batteries are fitted and the power switch (14) is off.
Press and hold the mode button (5) until the display starts to flash. Release
the mode button. You now have 5 seconds to start the next procedure
otherwise the display will stop flashing and return to showing normal time.
Whilst the display is flashing use the tuning up button (12) to adjust the
minutes and the tuning down button (15) to adjust the hours. After approx.
5 seconds the display will stop flashing and return to a normal time display.
The time is displayed in 24 hour format.
Search tuning
Press the power button (14) to turn on the receiver.
Select a waveband. Turn the volume control (2) until sound is audible.
Press and hold either the tuning up (12) or tuning down button (15) for more
than 1 second to start the search tuning facility. The receiver will continue
searching until a station of reasonable strength is found. To search for
additional stations it is only necessary to repeat the above operation.
Search tuning may be stopped by a single press of either the tuning up or
tuning down buttons.
Adjust the volume (2) and tone controls (3) to the desired level and tone of
sound.
Manual tuning
Press the power button (14) to turn on the receiver.
Select a waveband. Turn the volume control (2) until sound is audible.
Pressing the tuning up (12) or tuning down (15) buttons intermittently will
change the frequency up or down in steps. Each step is equal to 50kHz on
the FM band 9kHz on the medium waveband and 1kHz on the long
waveband.
Adjust the volume (2) and tone controls (3) to the desired level and tone of
sound.
Tuning indicator
The tuning indicator (10) will light up when stations are correctly tuned.
MHz
FM
4