Roland KR107 - Manual (Page 129)

129
Chapter 7 Creating and Editing Songs
Chapter 7
fig.d-rec-tempo.eps_50
3. Touch the <Rec Mode> to select <Tempo>.
This makes the setting for tempo recording.
Press the [Exit] button a number of times to switch to the
screen where the measure number is indicated in the
upper right of the screen.
When the KR goes into Tempo Recording, the tempo
indication is highlighted.
Recording the Tempo
4.
Use the [ (Bwd)] and [ (Fwd)] buttons to
move slightly before the measure where you want to
change the tempo.
5.
Press the [ (Rec)] button and watch the indicator is
flashing.
The KR is put in recording standby.
6. When you press the [ (Play/Stop)] button,
recording begins.
7.
When you get to the place where you want to change
the tempo, use the Tempo [-] and [+] buttons or the dial
to vary the tempo as desired.
8. When you press the [ (Play/Stop)] button,
recording stops.
The song’s tempo changes.
* You cannot record performances while in Tempo Recording
mode. When you’re finished tempo recording, go back to the
ordinary Replace Recording. Take a look at “Changing the
Recording Method (Rec Mode)” (p. 117).
■ Adjusting the Tempo at a
Particular Measure
You can create a tempo change at the beginning of a selected
measure. This is handy when you want to make a sudden
change in tempo.
First, carry out Steps 1–3 of “Changing the Tempo Within the
Song” (p. 128) to make the “Tempo Recording” settings.
1. Use the [ (Bwd)] and [ (Fwd)] buttons to move
to the measure where you want to change the tempo.
The measure number appears in the top-right area of the
Basic screen.
2. Press the [ (Rec)] button and watch the indicator is
flashing.
The KR is put in recording standby.
3.
Use the TEMPO [-] [+] buttons or the dial to change the
tempo.
4. Press the [ (Play/Stop)] button.
The song’s tempo changes starts with the measure you
selected.
→ While tempo recording is being used to write tempo, the tempo
display in the screen will be highlighted.
5. When you press the [ (Play/Stop)] button, the
change in tempo stops.
* You cannot record performances while in Tempo Recording
mode. When you’re finished tempo recording, go back to the
ordinary Replace Recording. Take a look at “Changing the
Recording Method (Rec Mode)” (p. 117).
→ If you want to restore the previous tempo, delete the tempo
data at the place where the tempo was recorded. For an
explanation of how to delete the information of tempo settings,
refer to “Making Measures Blank (Erase)” (p. 126).
Tempo Recording Shortcut
Hold down the [ (Rec)] button and press one of the
Tempo [-] [+] buttons to switch to the Tempo Recording
settings. Record tempo information. In this case, tempo
recording is canceled when recording ends.
KR107_e.book 129 ページ ２００５年８月３日 水曜日 午前９時３６分