Maintenance, Warning – RedMax BCZ2600SU User Manual
Page 20
20
9. Maintenance
■ REFILLING TRIMMING LINE (MA1)
1. For replacement line, use a diameter of .095in
(2.4mm). The spool is capable for a line upto 20ft
(6m) on the 4” head. Avoid using a larger line as
it may cut down the trimming performance.
For safety reasons, do not use metalreinforced
line.
2. Pinch the slotted area on the both sides of the
spool housing to unhook the bottom cap.
3. Take out the spool and pull off the old line. Put
one end of new line through the spool holes and
pull it until the length is equal between each part
of the line.
4. Wind up the line in the correct direction as
indicated on the spool.
5. Hook each end of the line in the slot on the edge
of the spool, and then put the ends through the
eyelets on the housing. Make sure that the
spring and the washers are in place.
6. While holding the spool against the housing, pull
the line ends to release them from the slot.
7. Line up the slot on the bottom cap with the hook
WARNING
every every every
25
50
100
system/compornent
procedure
before hours hours hours
note
use
after
after
after
fuel leaks, fuel spillage
wipe out
✔
fuel tank, air filter, fuel filter
inspect/clean
✔
✔
replace, if necessary
see
■ADJUSTING
replace carburetor
idle adjusting screw
✔
IDLING SPEED (p.18)
if necessary
clean and readjust
GAP: .025in(0.6~0.7mm)
spark plug
✔
plug gap
replace, if necessary
cylinder fins, intake air cooling vent clean
✔
muffler, spark arrester, cylinder exhaust port clean
✔
throttle lever, ignition switch
check operation
✔
replace if
cutting parts
✔
something's wrong
debris guard
make sure to attach
✔
gear case
grease
✔
screws/nuts/bolts
tighten/replace
✔
✔
not adjusting screws
E
N
G
I
N
E
S
H
A
F
T
■ MAINTENANCE CHART
MA1
Maintenance, replacement, or repair of the emission control device and systems may be
performed by any non-road engine repair establishment or individual.