Zanussi ZDT 16011 FA - Manual (Page 18)

Programme
1) Degree of soil
Type of load
Programme phases Energy
(kWh)
Water
(l)
Heavy soil
Crockery, cutlery, pots
and pans Prewash
Wash 70 °C
Rinses
Dry 1.4 - 1.6 15 - 16
3)
Fresh soil
Crockery and cutlery Wash 65 °C
Rinse 0.9 9
4) Normal soil
Crockery and cutlery Prewash
Wash 50 °C
Rinses
Dry 1.0 - 1.1 10 - 11
Normal or light soil
Delicate crockery and
glassware Wash 45 °C
Rinses
Dry 0.8 - 0.9 12 - 13
1) The display shows the programme duration.
The water pressure and temperature, the variations of the mains supply, the options and the quantity of
dishes can change the programme duration and the consumption values.
2) The appliance senses the degree of soil and the quantity of items in the baskets. It automatically adjusts the
temperature and quantity of the water, the energy consumption and the programme duration.
3) With this programme you can wash a load with fresh soil. It gives good washing results in a short time.
4) This is the standard programme for test institutes. With this programme you have the most efficient use of
water and energy consumption for crockery and cutlery with normal soil. Refer to the supplied leaflet for test
information.
Options
Multitab function
Activate this function only when you use the
combi detergent tablets.
This function deactivates the flow of rinse aid
and salt. The related indicators are off.
The programme duration can increase.
Activating the multitab function
Activate or deactivate the multitab function
before the start of a programme. You can-
not activate or deactivate this function while a
programme operates.
1. Press the on/off button to activate the appli-
ance.
2. Make sure that the appliance is in setting
mode. Refer to ‘SETTING AND STARTING
A PROGRAMME'.
3. Press and hold function buttons (D) and (E)
at the same time until the multitab indicator
comes on.
The function stays on until you deactivate
it. Press and hold function buttons (D) and
(E) at the same time until the multitab indicator
goes off.
If you stop to use the combi detergent
tablets, before you start to use separately
detergent, rinse aid and dishwasher salt,
do these steps:
1. Deactivate the multitab function.
2. Set the water softener to the highest level.
3. Make sure that the salt container and the
rinse aid dispenser are full.
4. Start the shortest programme with a rinsing
phase, without detergent and without
dishes.
5. Adjust the water softener to the water hard-
ness in your area.
6. Adjust the released quantity of rinse aid.
18
www.zanussi.com