Zanussi ZDT 16011 FA User Manual

Page 25

Advertising
background image

Problem

Possible cause

Possible solution

The fuse in the fuse box is damaged.

Replace the fuse.

The delay start is set.

Cancel the delay start or wait for the
end of the countdown.

The appliance does not fill
with water.

The water tap is closed.

Open the water tap.

The water pressure is too low.

Contact your local water authority.

The water tap is clogged or there is
limescale on it.

Clean the water tap.

The filter in the water inlet hose is
clogged.

Clean the filter.

The water inlet hose has a kink or a
bend.

Make sure that the position of the
hose is correct.

The anti-flood device is on. There are
water leakages in the appliance.

Close the water tap and contact the
Service.

The appliance does not
drain the water.

The sink spigot is clogged.

Clean the sink spigot.

The water drain hose has a kink or a
bend.

Make sure that the position of the
hose is correct.

After the checks are completed, activate the
appliance. The programme continues from the
point of interruption.
If the problem occurs again, contact the Serv-
ice.

If the display shows other alarm codes, contact
the Service.

The washing results and drying results are not satisfactory

Problem

Possible cause

Possible solution

The dishes are not clean.

The filters are clogged.

Clean the filters.

The filters are not correctly assem-
bled and installed.

Make sure that the filters are correctly
assembled and installed.

The spray arms are clogged.

Remove remaining soil with a thin
pointed object.

The programme was not applicable
for the type of load and soil.

Make sure that the programme is ap-
plicable for the type of load and soil.

Incorrect position of the items in the
baskets. Water could not wash all
items.

Make sure that the position of the
items in the baskets is correct and that
the water can easily wash all items.

The spray arms could not turn freely.

Make sure that the position of the
items in the baskets is correct and
does not cause the blockage of the
spray arms.

The quantity of detergent was not
sufficient.

Make sure that you add the correct
quantity of detergent in the dispenser
before you start a programme.

25

www.zanussi.com

Advertising