Ryobi P220 - Manual (Page 13)

13
OPERATION
INSERTING BITS
See Figure 6.
n
Lock the trigger switch by placing the rotation selector
in the center position.
n Position the chuck jaws so that the opening is slightly
larger than the drill bit you intend to use.
NOTE: To open the chuck jaws, turn the chuck sleeve
counterclockwise. To close the chuck jaws, turn the
chuck sleeve clockwise.
n Raise the front of the drill to keep the drill bit from falling
out of the chuck jaws.
WARNING:
Do not insert a drill bit into the chuck jaws and tighten
as shown in Figure 7. This could cause the drill bit to be
thrown from the drill resulting possible serious injury or
damage to the chuck.
n Insert the drill bit completely into the chuck.
n Tighten the chuck jaws securely on the drill bit. Do not
use a wrench to tighten or loosen the chuck jaws.
REMOVING BITS
See Figure 6.
n
Lock the trigger switch by placing the rotation selector
in the center position.
n Loosen the chuck jaws.
n Remove the drill bit from the chuck jaws.
15
Fig. 6
Fig. 7
RIGHT
LOCK
(Tighten)
CHUCK JAWS
CHUCK SLEEVE
DRILL BIT
UNLOCK
(Release)
15
WRONG