Radio Shack VG-2 Guard - Manual (Page 17)

17
3. Clean the windshield where the detector will be
mounted.
4. Position the bracket on the windshield and press
firmly on each suction cup.
5. If necessary, you can adjust the angle by removing
the detector and bending the windshield bracket.
Caution: Bending the bracket with the detector
installed may damage the bracket.
To remove the windshield bracket from the bracket
holder, first detach the bracket holder from the detector,
then pull up the small locking bar at the center of the
bracket and pull the bracket out of the slot.
CONNECTING POWER
Plug the supplied power cord’s barrel plug into the DC
12V jack on the side of the detector. Make sure the
knurled ring on the tip of the plug is firmly screwed in,
then plug the power cord’s cigarette-lighter plug into
your vehicle’s cigarette-lighter socket.
22-1676.fm Page 17 Friday, August 6, 1999 10:38 AM